Installer Test

  1. After finishing the INSTALLER SETUP the N100 enters INSTALLER TEST mode.

  2. The display will show the current test mode. To test the mode displayed, press . If testing Heat or Cooling on multi-stage equipment, a second press of the button will indicate a call for Stage 2.

  3. Press NEXT to advance to the next mode in the test menu. Possible settings in the test menu are Heat, Cool, Em Heat and Fan.

System Test:

Code Description

Tests only available for stages configured on thermostat.

Heat

0

All Off

1

Heat Stage 1 on

2

Heat Stage 2 also on

3

Heat Stage 3 also on

Cool

0

All Off

1

Cool Stage 1 on

2

Cool Stage 2 also on

EM Heat

(Emergency Heat)

0

All Off

1

EM Heat on

Fan

0

Fan Off

1

Fan On

Note: If ISU 1060 is set for a wired outdoor sensor, that sensor reading is shown in display after cycling through the Installer test menu but is not shown on home screen.