UWP Wall Plate Installation

If the cover plate is used, the UWP snaps on the cover plate as shown here.

1. Before starting, turn the power off at the breaker box or switch. Open the package to find the UWP. See Figure 1.

2. Position the UWP on wall. Level and mark hole positions. See Figure 2.

3. Using a 3/16" bit, drill holes at marked positions and then lightly tap the supplied wall anchors into the wall using a hammer.

4. Pull the door open and insert the wires through wiring hole of the UWP. See Figure 3.

5. Place the UWP over the wall anchors. Insert and tighten mounting screws supplied with the UWP. Do not overtighten. Tighten until the UWP no longer moves. Close the door. See Figure 4.

Use 3x supplied #6 1-1/2" screws

If the Optional Cover Plate is not required, see UWP Wall Plate Installation.

Use the Optional Cover Plate when you need to cover a paint gap from the old thermostat.

1. Separate the Cover Plate from Mounting Plate (Figure 1).

2. Mount the Mounting Plate on to the wall or J-box using any of the 8 screw holes. Insert and tighten mounting screws supplied with Cover Plate Kit. Do not overtighten. See Figure 2. Make sure the Mounting Plate is level.

3. Attach the UWP by hanging it on the top hook of the Mounting Plate and then snapping the bottom of the UWP in place. See Figure 3.

4. Snap the Cover Plate onto the Mounting Plate. See Figure 4.