Specifications


T10 & T10+ Thermostat Description.

Feature

Description

Powering Method

Common wire required

Stages:

Up to 3H/2C* Heat pump

Up to 2H/2C* conventional

Radiant floor with slab sensor (T10+ only)

Equipment type:

  • Dual fuel

  • Hot water, steam, or hot water coil

  • Gas or oil furnace

  • High-efficiency or mid-efficiency

  • Cool only

  • Humidifier, Dehumidifier, or Ventilator control**

Changeover

Manual or Auto Changeover Selectable

System Setting

Em Heat-Heat-Off-Cool-Auto

Fan Setting

Auto-On-Circ. Multiple speed settings for 2-pipe or 4-pipe fan coil units

*4H/2C heat pump or 3H/4C conventional with T10+ & EIM.

** T10+ with EIM can control three IAQ devices.

Electrical ratings of T10 or T10+ Without EIM.

Terminal

Voltage (50/60Hz)

Running Current

W (Heat)

20-30 VAC

0.02-1.0 A

W2 (Aux) Heat

20-30 VAC

0.02-1.0 A

E (Emergency Heat)

20-30 VAC

0.02-0.5 A

Y (Compressor Stage 1)

20-30 VAC

0.02-1.0 A

Y2 (Compressor Stage 2 or stage 2 fan)

20-30 VAC

0.02-1.0 A

G (Fan)

20-30 VAC

0.02-0.5 A

O/B (Changeover)

20-30 VAC

0.02-0.5 A

L/A (Typically Heat Pump Fault)

20-30 VAC

0.02-0.5 A

U (Hum, Dehum, or Vent)

20-30 VAC

0.02-0.5 A

Power Consumption: 3VA

Electrical ratings of EIM (for use with T10+ models).

Terminal

Voltage (50/60Hz)

Max. Current Rating

O/B

18-30 VAC

1.00 A

Y (Compressor Stage 1)

18-30 VAC

1.00 A

Y2 (Compressor Stage 2 or stage 2 fan)

18-30 VAC

1.00 A

G (Fan)

18-30 VAC

0.50 A

W1

18-30 VAC

0.60 A

W2/Aux 1 (Heating)

18-30 VAC

0.60 A

W3/Aux 2 (Heating)

18-30 VAC

0.60 A

L (Input only)

18-30 VAC

0.60 A

U1, U1

U2, U2

U3, U3

18-30 VAC

0.50 A


RedLINK Communication:

Frequency: 900 MHz frequency range

Re-Sync Time: RedLINK devices re-establish communication within 6 minutes after AC power resumes.

Temperature Setting Range:

Heating: 40 to 90 °F (4.5 to 32 °C).

Cooling: 50 to 99 °F (10 to 37 °C).

NOTE: Adjustable high and low range-stop settings.

Humidification Setting Range:

0% to 90% RH.

Dehumidification Setting Range:

10% to 100% RH.

Humidity Display Range:

0% to 99%.

Humidity Sensor Accuracy:

± 5% RH from 30% to 50% RH at 75 F.

Cool Indication:

Display floods blue and says "Cooling to" when Cool is on.

Heat or Em Heat Indication:

Display floods orange and says "Heating to" when Heat is on.

AUX Heat Indication:

Display shows “Aux Heat On” above the room temperature.

Interstage Differential:

Comfort (default setting):

The thermostat keeps the indoor temperature within 1 degree of the setpoint (Differential less control). Unless the system is dual fuel, or a Differential setting is used, the thermostat turns on stage 2 when the capacity on stage 1 reaches 90%.

  • See ISU 3030 for cool differential options.

  • See ISU 3050 and ISU 3090 for Backup Heat Differential options.

Clock Accuracy:

1 minute per month at 77 °F (25 °C). ± 2 minutes per month over the operating ambient temperature range. Automatically updates when connected to WiFi router and registered to account.

Mounting Means:

Thermostat mounts directly on the wall in the living space using mounting screws and anchors provided. Can mount to a horizontal 2 x 4 in. junction box using J-Box adapter (included).


Model Numbers

T10+ and Accesories

Product

Part Number

Operating Ambient Temperature

Operating Relative Humidity

Shipping Temperature

Dimensions in in. (mm)

Color

T10+ thermostat

THX321WF3003W

T10 +

37 to 102 °F.

(2.8 to 38.9 °C)

5% to 90%

Non-Condensing

-20 to 120 °F

(-28.9 to 48.9 °C)

T10+

4.9" H x 3.7" W x 0.93" D

(125.4mm H x 94.1mm W x 23.68mm D)

White

Kit with T10+ thermostat with one C7189R3002 sensor

THX321WFS3001W

Same as THX321WFS3001W kit except updated trim ring and bold idle screen font and updated cover plate

THX321WFS3024W

Kit with T10+ Thermostat, EIM, IAS, RATS/DATS

YTHM1004R3000

Same as YTHM1004R3000 kit except updated trim ring and bold idle screen font and updated cover plate

YTHM1004R3024

Kit with T10+ Thermostat, EIM, IAS, RATS/DATS, OAS

YTHM1004R3001

Wireless indoor temperature, humidity, & motion sensor. Up to 20 per T10+ thermostat. (IAS)

C7189R3002-2
(2-pack)

*0 to 120 °F

(17.8 to 48.9 °C)

5% to 90%

Non-Condensing

-20 to 120 °F

(-28.9 to 48.9 °C)

2.6" W x 2.6" H x 0.78" D

(66.25 W x 66.25 H x

19.7 D)

White

Wireless outdoor temperature & humidity sensor (OAS)

C7089R3013

-40 to 140 °F

(-40 to 60 °C)

0% to 90%

Non-Condensing

-40 to 140 °F

(-40 to 60 °C)

5" x 3-1/2" x 1-11/16"

(127 x 89 x 43)

Grey

Equipment Interface Module (EIM)

THM04R3000

-40 to 165 °F

(-40 to 73.9 °C)

5% to 95%

Non-Condensing

-20 to 165 °F

(-28.9 to 73.9 °C)

4-53/64" W x
9-11/32" H x

1-19/32" D

(123  W x 237 H x 41 D)

Grey

Floor/Slab sensor for radiant floor heat (T10+ only. 10K ohm)

AC112-01

 

Discharge or return sensor. (Two are included with the T10+ & EIM kits)

C7735A1000

* For optimal battery life, operating temperature range of 35 to 114 °F (1.7 to 45.6 °C) is recommended.

Accesories for either T10 or T10+

Product

Part Number

Dimensions in in. (mm)

Large Cover Plate & J Box Adapter Included with T10 & T10+ models other than THX321WFS2001W

THP2400A1080

6.11" W x 6.11" H (155.3 X 155.3)

Large molded Cover Plate & J Box Adapter Included with THX321WFS2001W model of T10 & T10+ models

Cannot be ordered as a separate accessory

5-1/2" W x 5-13/64" H (140 x 131)

Wired indoor temperature sensor (10K ohm)

C7189U1005

1-1/2" W x 2-1/4" H x 3/4" D (38 W x 57 H x 19 D)

Wired outdoor temperature sensor (10K ohm)

C7089U1006

2-1/4" W x 3/8" H with 60" lead wires
(57 x 10 with 1524 mm lead wires)

Wire saver module or C wire adapter (add a C wire).

Various versions of this made. Starts with THP9045A

 

 

T10 Thermostats and Accessories (No longer available)

Product

Part Number

Operating Ambient Temperature

Operating Relative Humidity

Shipping Temperature

Dimensions in inches (mm)

Color

T10 thermostat (Discontinued)

THX321WF2003W

T10 Thermostat

37 to 102 °F

(2.8° to 38.9° C)

5% to 90%

Non Condensing

-20 to 120 °F

28.9 to 48.9 °C)

T10 Thermostat

4.9" H x 3.7" W x 0.93" D

(125.4 H x 94.1 W x 23.68 D)

White

Kit with T10 thermostat with one C7189R2002 sensor (Discontinued)

THX321WFS2001W

Wireless indoor temperature, humidity, & motion sensor. Up to 20 per T10 thermostat (Discontinued)

C7189R2002-2

(2 pack)

 

*0 to 120 °F

(-17.8° to 48.9°C)

5% to 90%

Non-Condensing

-20 to 120 °F

(-28.9 to 48.9 °C)

2.6" W x 2.6" H x .78" D (66.25 W x 66.25 H x 19.7 D)

White

* For optimal battery life, operating temperature range of 35 to 114 °F (1.7 to 45.6 °C) is recommended.

Dimensions

Dimensions of T10 & 10+ thermostat in inches (mm)

Dimensions of C7189R3002 & C7189R2002 sensors in inches (mm)

Dimensions of THM04R3000 EIM in inches (mm)

Dimensions of C7089R3013 wireless outdoor sensor in inches (mm)

Dimensions of J-Box adapter included with all T10 & T10+ models in inches (mm)

Dimensions of molded grey cover plate included with THX321WFS2001W in inches (mm)

Dimensions of flat white cover plate included with all T10 & 10+ models other than THX321WFS2001W in inches (mm)