Installer Setup Options - Fan Coil Unit

This does not show all the ISU settings available when Fan Coil is selected. These categories are intended to display only the settings specific to those applications. Other settings—such as temperature limits, IAQ control (humidifier, dehumidifier, ventilator), etc.—will be shown for all system types.

ISU #

Heading

Question

Options

Contingent previous setting?

Notes

2000

System Type

System Type

  • Conventional Forced Air Heat

  • Heat Pump

  • Radiant Heat

  • None (Cool only)

 

It is important that this is set correctly. If you are unsure about what type of system you have contact an HVAC professional to assist.

Watch "Identify your heating and cooling system” video.

2010

Equipment type

Equipment type

  • Standard Efficiency Gas Forced Air

  • High Efficiency Gas Forced Air

  • Oil Forced Air

  • Electric Forced Air

  • Hot Water Fan Coil

2000 = Conventional Forced Air Heat

This setting not shown for Heat Pump Applications.

Equipment type

  • Hot water radiant heat

  • Steam

2000 set to Radiant Heat

This setting not shown for Heat Pump Applications.

Not seeing these settings? Refer to the note at the top of this chart.

2070

Equipment stages

Cool stages

  • 0-2 stages

2000 set to other than Heat Pump

Heat stages

  • 1-2

 

Use for conventional heating systems such as a gas forced air furnace.

Compressor Stages

  • 1

  • 2

2000 set to Heat Pump

 

Backup Heat Stages

  • 0

  • 1

2000 set to Heat Pump

3260

Temperature

Control

Extended fan run time in cool

  • Off

  • 30 seconds

  • 60 seconds

  • 90 seconds

  • 2 minutes

  • 3 minutes

  • 4 minutes

  • 5 minutes

  • 6 minutes

  • 7 minutes

  • 8 minutes

  • 9 minutes

  • 10 minutes

  • 11 minutes

  • 12 minutes

  • 13 minutes

  • 14 minutes

  • 15 minutes

At least 1 cool stage

 

Extended fan run time in heat

At least 1 heat stage